The Chopard watch is a high-end Swiss watch brand, so we must be extra careful in our daily use. Here is a small introduction to Chopard watch maintenance tips:
1. Soak in gasoline and wash i.e. soak in gasoline and wash to solve the problem of oil scale accumulating and blocking the watch for a long time and to maintain the watch.1.
2. Check the internal parts of the watch, and if you find a broken screw cap, use a watch screwdriver to screw it out. Then take out the broken screw, you can achieve the problem of dealing with the internal parts of the watch failure, in order to achieve the purpose of maintaining the watch.
3. Clean the watch oil. The bar shaft rotation is not flexible, and the long-term accumulation of grease blockage is one of the factors causing the watch failure, the obstruction is serious in fact, hoop solid, then hard on the bar is bound to cause folding teeth, so it is advisable to soak in gasoline and wash can be solved. The axial or radial clearance between the bar box wheel and the bar box cover is another factor that causes the watch to rotate, which should be carried out with reference to the repair method of the bar box wheel. 4. Remove the broken screw cap of the watch, which will affect the performance of the watch if left untreated for a long time. The screw of the big steel wheel of the watch is broken inside the thousand bar shaft, the screw of the big steel wheel is mostly used in the positive rotation screw, a few foreign mechanical watches use the reverse rotation screw, without understanding its rotation direction and excessive force will often happen when the screw cap breaks off, the big steel wheel loses the fastening of the screw, when the watch is on the bar, it will come out from the bar shaft square god section, and cannot drive the bar shaft to tighten the winding. If the length of the screw remaining in the bar shaft is exposed to the bar shaft, the broken screw can be bitten by the clamp and screwed out according to the direction of screwing out, and when the broken screw is equal to the top of the bar shaft, the turning tool tip can be used to hold the edge of the broken screw in several places to spin it loose. Broken watch screws slightly lower than the top surface of the bar shaft square birch, also available thin file (commonly known as nail file) in the top surface of the bar shaft square Zen first file a groove, the corresponding residual screws also open the starter slot, and then use the table screw driver to spin it out, and then remove the broken screw, you can achieve the problem of dealing with the internal parts of the watch failure to increase the working life of the watch. Warm Tips: The latest market trends are always available, please follow LuFuture.com app..
Chopard, Cap,